INSTRUCTIONS:
|
|
Using and Printing Ink Jet Decal Paper: 1. Using your computer, design and create your own custom decal 2. Set your printer’s resolution to “Highest” or “Best” and choose “Photo” or “Gloss” for your paper option (you will be printing on the “glossy” side of the decal paper). 3. After printing your decal,
use Krylon’s® Acrylic Crystal
Clear High Gloss
Spray and apply
an even shine on the sheet. Allow 45 – 60 minutes drying time.
NOTE: Due to shipping regulations, we are unable to ship Krylon acrylic spray with our Inkjet decal paper.
You can buy this locally. It is available at Loews, Home Depot, Ace Hardware, Walmart, etc. Any acrylic clear coat spray will work.
Note that the laser/color copier paper does not require application of the spray. 4. Carefully cut and remove
your decal using a pair of scissors. Immerse the decal in a wide bowl
of water for 30 - 60 seconds and remove once you see that the film detaches
from the backing material. 5. Your decal is now ready
to be applied. Please make sure all surfaces are clean before applying
the decal. Carefully place and position the decal on the object. Gently
remove the backing paper and hold in position for approximately 30 seconds
while the decal sets. Add water to the surface as needed, patting dry
the decal. You may seal the decal with a gloss spray finish.
Using
and Printing Laser Decal Paper: 1.
Using your computer,
design and create your own custom decal 2.
Set your printer’s resolution
to “Highest” or “Best” and choose “Photo” or “Gloss” for your paper
option (you will be printing on the “glossy” side of the decal paper). 3.
Carefully cut and remove your decal using a pair
of scissors. Immerse the decal in a wide bowl of water for 30 - 60
seconds and remove once you see that the film detaches from the backing
material. 4.
Your decal is now ready to be applied. Please
make sure all surfaces are clean before applying the decal. Carefully
place and position the decal on the object. Gently remove the backing
paper and hold in position for approximately 30 seconds while the decal
sets. Add water to the surface as needed, patting dry the decal. You
may seal the decal with a gloss spray finish. Using
and Printing Temporary Tattoo Paper 1. Using your computer, design and create your own custom
tattoo. 2. Set your printers resolution to “Normal” and choose
“Plain Paper” as your paper option. (NOTE: Please allow the printed
tattoo paper to dry thoroughly for 3 – 4 minutes prior to handling) 3. Always feed one sheet at a time when printing. 4. Remove the first
side of the Adhesive Sheet and carefully apply it to the printed tattoo
sheet. Be sure to remove all air bubbles. 5. Using a pair of
scissors, carefully cut out each tattoo design. (Tip: When cutting,
try to keep as close to the edge of the tattoo design as possible) 6. Your tattoo will
work best if applied to skin that is clean, dry and free of body hair.
7. Carefully remove the adhesive backing and apply the
tattoo to skin, pressing firmly for approximately 20 seconds. 8. Using a damp sponge,
wet the tattoo for 45 – 60 seconds until the paper is completely wet.
9. Remove the backing to reveal the tattoo. NOTE: Tattoo paper must be stored
in a cool dry place. We recommend you store the paper in its original
plastic bag and always on a flat surface. |
 |
 |
 |
|